2004 650 Twin Arctic Cat ATV Service Manual, Page 107Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 107

5Turn the ignition switch to the LIGHTS position6Connect the red tester lead to the red wire; then connect the black tester
starter button released, the meter must show an open circuit5Connect the red tester lead to the yellowgreen wire; then connect
the black tester lead to the orange wire6With the starter button depressed, the meter must show an open circuitNOTE: If the
meter does not show as specified, replace the switchcomponent, connector, or switch harnessRESISTANCE (Emergency Stop) Handlebar
Control Switches The connector is in front of the steering postTo access the connector, the front rack and front fenders
must be removed (see Section 8)NOTE: These tests should be made on the top side of the connector 1Set the meter selector
to the OHMS position2Connect the red tester lead to the orange wire; then connect the black tester lead to the orangewhite
wire3With the switch in the OFF position, the meter must show an open circuit4With the switch in the RUN position, the meter
must show less than ohmNOTE: If the meter shows more than ohm of resistance, troubleshoot or replace the switchcomponent,