2004 650 Twin Arctic Cat ATV Service Manual, Page 108Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 108

4Connect the red tester lead to the blue wire; then connect the black meter lead to the black wireThe meter must show an
and on the selector-side of the connectorRESISTANCE 1Select the 2WD position on the front drive selector switch; then disconnect
the four-prong connector on the actuator wiring harness2With the ignition switch in the OFF position, connect the black tester
lead to the black wire in the supply harness; then connect the red tester lead to the orange wire in the supply harness3Turn
the ignition switch to the ON positionThe meter must show 12 D.Cvolts4Connect the red tester lead to the whitered wire in
the supply harnessThe meter must show 12 D.Cvolts5Select the 4WD position on the front drive selector switch; then connect
the red tester lead to the whitered wire in the supply harnessThe meter must show D.Cvolts6Connect the red tester lead to
the orange wire in the supply harnessThe meter must show 12 D.CvoltsNOTE: If the voltage readings are as specified and the
actuator does not function correctly, replace the actuator (see Section 6) ! CAUTION Always disconnect the battery when performing