2004 650 Twin Arctic Cat ATV Service Manual, Page 109Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 109

3Turn the ignition switch to the ON position and select WD on the front drive selector switch; then while watching the meter
performing resistance tests to avoid damaging the multimeter 1Set the meter selector to OHMS position2Test between the three
black wires for total of three tests ! CAUTION Do not run the engine at high RPM for more than 10 secondsNOTE: If voltage
is lower than specified, test charging coilno loadVOLTAGE (Charging CoilNo Load) The connector is the white one on the right
side behind the engineNOTE: Test the connector that comes from the engine 3The meter reading must be within specificationRESISTANCE
(Trigger Coil) 1Set the meter selector to the A.CVoltage position2Test between the three black wires for total of three tests
! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the multimeter 1Set the meter
selector to the OHMS position2Connect the red tester lead to the blackwhite wire; then connect the black tester lead to the