2004 650 Twin Arctic Cat ATV Service Manual, Page 122Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 122

100-Hour Belt Inspection Mode Clearing Every 100 hours, the belt indicator light will illuminate to alert for inspectionSee
off4Turn the ignition switch to the OFF position; then remove the reset connector5Connect the 4-pin connector and the belt
indicator light switch connector; then turn the ignition switch to the ON positionThe belt indicator light should go off
2Use the multimeter and select the ohms function; then measure resistance as follows: pins (red)(black), 3-15 ohms; pins
(orange)(blue), 3500-6500 ohms; pins (yellow)(blue), 630-5330 ohmsIf readings are not as specified, replace the engine brake
actuator Engine Brake Actuator Resistance 1Remove the air duct boot; then disconnect the actuator lead connector (A) ATV2143A
Engine Brake Controller Power Supply Voltage NOTE: For the following tests, make sure the battery is fully chargedNOTE: Needle
adapters will be required on the multimeter leads as these tests are made with the controller connected 1Select D.CVoltage