2004 650 Twin Arctic Cat ATV Service Manual, Page 123Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 123

3If battery voltage is not present, check the 30-amp fuse, ignition switch, or wiring harness ForwardReverse Detecting Sensor
to the brownwhite wire terminal (15) and the black tester lead to the black wire terminal (10) in the controller (A) Output-to-Actuator
Voltage ATV2145 2Turn the ignition switch ON and spin rear wheel in the forward direction; then allow the wheel to stopAfter
at least one second, turn the ignition switch OFF3After two seconds, observe the meter until the actuator stopsThe controller
output voltage should vary from 5-12 D.CvoltsIf the voltage is not within specifications, check the forwardreverse detecting
sensorIf the sensor is normal, replace the actuator controller Select D.CVoltage on the multimeter (B) and turn the ignition
switch ON; then connect the red tester lead to the blackgreen wire terminal (2) and the black tester lead to the black wire