2004 650 Twin Arctic Cat ATV Service Manual, Page 124Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 124

ATV2146 ATV2147 Output-to-Speed Sensor Voltage Select D.CVoltage on the multimeter (B), disconnect the speed sensor connector,
Incorrect installation of the tilt sensor could cause sudden loss of engine power which could result in loss of vehicle control
resulting in injury or death ! CAUTION Do not drop the tilt sensor as shock can damage the internal mechanismSUPPLY VOLTAGE
ATV2147 1Disconnect the three-wire connector (A); then select D.CVoltage on the multimeter (B) and connect the red tester
lead to the orange wire terminal (C) and the black tester lead to the black wire terminal (D) (harness side) Speed Sensor
Signal Voltage 1Support the ATV on stand or suitable jack so the wheels are off the ground; then turn the ignition switch