2004 650 Twin Arctic Cat ATV Service Manual, Page 125Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 125

2Install the needle adapters (E) to the multimeter leads; then select D.CVoltage on the multimeter (D)3Connect the red tester
the blue wire terminal (E)The multimeter should read 5.0 D.CvoltsIf the specified voltage is not indicated, check the CDI
unit ATV2150 ATV2149 OUTPUT VOLTAGE NOTE: Needle adapters will be required on the multimeter leads as the following tests
are made with the sensor connected 4Tilt the sensor (H) 60-70 left and right observing the meterThe meter should read 3.7-4.4
D.Cvolts after approximately one second in the tilted positionIf the meter readings are not as specified, replace the tilt
sensor5Install the mounting screws making sure the sensor lead is directed toward the rear of the ATV and the UP arrow is