2004 650 Twin Arctic Cat ATV Service Manual, Page 130Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 130

Front Drive Actuator NOTE: The actuator is not serviceable componentIf it is defective, it must be replacedNOTE: The actuator
must be replacedREMOVING 1Remove the left-front inner fender panel; then disconnect the three-prong connector on the actuator
harness2Using T-30 torx wrench, remove the mounting cap screw from the driveshaft side of the actuatorINSTALLING 1Ensure
that all mounting surfaces are clean and free of debrisNOTE: Apply Arctic Cat ATV High-Performance Grease (pn 0436-501) to
the O-ring surface 2Place the O-ring into position; then align the actuator with the selector shaft and slide it forward
onto the shaft taking care to engage the cap screw in the slot of the front mounting tab 3Remove the mounting cap screw from
below the actuator on the suspension side 3While holding the actuator firmly forward, tighten the front cap screw to hold