2004 650 Twin Arctic Cat ATV Service Manual, Page 131Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 131

4Loosen the front cap screw; then tighten the cap screw on the driveshaft side 4Pump up the hand brake; then engage the brake
tie; then install the inner fender panelNOTE: Make sure that the wiring harness is clear of the exhaust pipe and left-side
tie rod NOTE: It is not necessary to remove the brake hoses from the calipers for this procedure 6Remove the brake calipersAccount
for the cap screws Front Differential NOTE: To remove the rear gear case, see Rear Gear Case in this sectionAF894D REMOVING
DIFFERENTIAL 1Secure the ATV on support stand to elevate the wheels 7Remove the tie rod cotter pins and discard the pins
! WARNING Make sure the ATV is solidly supported on the support stand to avoid injury 2Remove the filler plug and the drain