2004 650 Twin Arctic Cat ATV Service Manual, Page 141Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 141

2Using propane torch, heat the area surrounding the needle bearing to approximately 300 11Making sure the O-ring is properly
gear housing is being installed, tighten the cap screws to 3.5-4.3 kg-m (25-31 ft-lb) 3Using flat-nosed punch, drive the
bearing out of the housing Removing Needle Bearing NOTE: Removing the needle bearing is rarely necessaryAvoid removing the
needle bearing unless the bearing is clearly damagedNOTE: This procedure can be performed on rear gear caseCC887 1Place 6.35