2004 650 Twin Arctic Cat ATV Service Manual, Page 143Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 143

NOTE: Prior to installing the seal, apply grease to the seal outside diameter 4Install the seal into the housing pressing
the cap screws, washers, and flex-lock nutsTighten to 6.2 kg-m (45 ft-lb)Make sure the rubber boot is properly seated on
the input yoke 3Install the front drive actuator and tighten the screws securely; then connect the lead to the main harness
4Install the inner fender panelsNOTE: To secure the side panels, use torx-head screw and three cable ties per side 5Install
the front axles (see Drive Axles in this section)KX161 6Secure the upper A-arms with cap screws and lock nutsTighten to 4.8