2004 650 Twin Arctic Cat ATV Service Manual, Page 145Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 145

NOTE: Do not allow brake caliper to hang from its hose REMOVING FRONT DRIVE AXLE 1Secure the ATV on support stand to elevate
nut and washerRelease the brake lever lock NOTE: Never reuse lock nutOnce lock nut has been removed, it must be replaced
with new lock nut 8While holding the drive axle stationary, pull the top of the knuckle out and down until it is free of
the drive axle9Place drain pan under the ATV to contain any oil leakage; then using slide hammer, remove the drive axle NOTE:
It is not necessary to remove the brake hose from the caliper for this procedure 5Remove the brake caliperNOTE: Support the