2004 650 Twin Arctic Cat ATV Service Manual, Page 148Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 148

2Using the boot clamp pliers, secure the small clamp of the inner boot 5Secure the bearing ring with the circlip making sure
slide the housing over the bearing ring; then install the circlip ATV-1052 7Slide the boot over the housing; then using the
boot clamp pliers, secure the boot with the clamp 4Install the bearing onto the shaft making sure the recess of the bearing
is facing the housing 8Inspect the axle components for correct positioning of the four clampsAlso, inspect the boots for
being correctly positioned on the shaftINSTALLING REAR DRIVE AXLE 1Apply Arctic Cat ATV High-Performance Grease (pn 0436-501)