2004 650 Twin Arctic Cat ATV Service Manual, Page 149Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 149

NOTE: To assure proper seating of the axle, give it light pull; the axle should remain "clipped" in place 4Slide the hub
cap screws to 2.1 kg-m (15 ft-lb)Tighten the hydraulic brake caliper cap screws to 2.8 kg-m (20 ft-lb)5Pump up the hand brake
lever; then engage the brake lever lock6Tighten the hub hex nut (from step 3) to 17.5 kg-m (125 ft-lb); then install and
spread new cotter pin making sure each side of the pin is flush to the hub nut 7Install the wheel and tighten to 5.5 kg-m
(40 ft-lb)8Remove the ATV from the support stand and release the brake lever lock9Check the front differential oil level
and add oil as necessaryKX041 7Install the wheelTighten to 5.5 kg-m (40 ft-lb)8Remove the ATV from the support stand and
release the brake lever lock9Check the enginetransmission oil level and add oil as necessaryINSTALLING FRONT DRIVE AXLE 1Position
the drive axle in the gear case and steering knuckle; then insert the upper A-arm ball joint into the steering knuckleSecure
with cap screw tightened to 4.8 kg-m (35 ft-lb)2Place the brake hose into position on the upper A-arm; then secure the lower