2004 650 Twin Arctic Cat ATV Service Manual, Page 152Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 152

9Remove the ATV from the support stand CLEANING AND INSPECTING 1Clean all caliper components (except the brake pads) with
are not scratched ! WARNING Make sure the ATV is solidly supported on the support stand to avoid injury 2Install the brake
pads and secure with the pin and cotter pin 2Drain the brake fluid from the entire hydraulic system (reservoir, hoses, and
caliper) 3Place the brake caliper assembly into position and secure with the cap screwsTighten the caliper to 2.8 kg-m (20
ft-lb)4Place new crush washer on each side of the brake hose fitting and install it on the caliperTighten to 4.2 kg-m (30
ft-lb)5Fill the reservoir; then bleed the brake system (see Section 2)6Install the wheelTighten to 5.5 kg-m (40 ft-lb) !