2004 650 Twin Arctic Cat ATV Service Manual, Page 167Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 167

Handlebar Grip REMOVING 1Remove the plug from the head of the rivet2Using 18-indrill bit, drill out the rivet3Using compressed
1Apply liberal amount of Handlebar Grip Adhesive (pn 0636-071) to the inside of the grip2Align the rivet hole in the grip
with the rivet hole in the handlebar; then align the notch (inside the grip) with the slot in the handlbar and slide the
grip onto the handlebar until it is fully seated3Wipe off any excess glue; then secure the grip with new rivet4Install the
plug on the head of the rivet 8Place the storage compartmentair filter cover into position; then secure with the two cap
screws Steering Knuckles REMOVING AND DISASSEMBLING 1Secure the ATV on support stand to elevate the wheel; then remove the
wheel 9Install the storage compartment cover with the four snap fasteners10Install the seat (see Seat in this section) !
WARNING Make sure the ATV is solidly supported on the support stand to avoid injury 2Remove the wheel cap from the hub; then