2004 650 Twin Arctic Cat ATV Service Manual, Page 176Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 176

8Disconnect the wires from the accessory plug (if equipped); then remove the accessory plug from the fender9Remove the fenders
accessory plug wiresNOTE: The accessory plug red wire goes on the center connector 3Install the cap screws (five per side)
securing the fenders to the frame and footrests and finger-tighten; then tighten the ten fasteners securely4Connect the drive
selector linkage using existing hardwareTighten securely Fender Flares Extensions REMOVING 1Using side-cutter, remove the
appropriate plastic rivetsNOTE: To remove front extension, first remove the grille; then remove the push nuts securing the
extension to the bumper 2Remove the cap screws securing the extensions or flares to the frame and footrest3Remove the self-tapping
screws securing the extension to the fenderINSTALLING 5Install the gear shift linkage cover in the left-front fender wellTighten