2004 Arctic Cat ATVs factory service and repair manual, Page 14Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 14

3Remove the vent plugs; then (if necessary) fill the battery with distilled water to the upper level indicated on the battery4Trickle
charging7check fluid level and fill with distilled water as necessary; then install vent plugs Before installing the battery,
make sure the ignition switch is in the OFF position 6Place the battery into position in the ATV and secure with the hold-down
bracket 7Attach the vent tube and check the vent tube to make sure it is not crimped or obstructed in any way and that it
is properly routed through and secured to the frame 2501300 10 IGN 15 LIGHTS 10 ACC 10 SPARE 10 LIGHTS 10 HIGH 10 LO 10 IGN
8Connect cables to the proper terminals: positive cable to the positive terminal (+) and negative cable to the negative terminal
(-1Connect the negative cable last 15 FAN 15 ACC Connecting cables in reverse (positive to negative and negative to positive)