2004 Arctic Cat ATVs factory service and repair manual, Page 25Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 25

6Apply oil to new cover O-ring and check to make sure it is positioned correctly in the coverWith the open end of the filter
and properly discard the O-ring from the filter cover 8Install the engine drain plugs and tighten to 2.2 kg-m (16 ft-lb)Pour
3.5 (3.7 U.Sqt) ofthe recommended oil in the filler hole; then install the filler plug A CAUTION Any oil used in place of
the recommended oil could cause serious engine damageDo not use oils which contain graphite or molybdenum additivesThese
oils can adversely affect clutch operationAlso, not recommended are racinu, vegetable, non-detergent, and castor-based oil
9Start the engine (while the is outside on level ground) and allow it to idle for few minutesWNOTE: Clean up any excess oil
after removing the filter 10Turn the engine off and wait approximately one minuteRecheck the oil level in the engine oil
inspection windowThe oil level should be visible through the windowIf oil is not visible, add recommended oil until the oil