2004 Arctic Cat ATVs factory service and repair manual, Page 28Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 28

2Remove the cat) screws securing the oil strainer cap; then remove the capAccount for the O-ring 6Install the skid plateCC091D
be inbelow the threads of the plugIf low, add SAE approved SOW-90 hypoid gear lube as necessaryCC163D I NOTE: To service
oil strainer, see Section 3 4Place the oil strainer into position beneath the crankcase and secure with the Phillips-head
cap screwsTighten securely 2On ACT models, remove the rear drive inspection plug; the lubricant level should be at the threads
of the plugIf low, add SAE approved SOW-90 hypoid gear lube as necessary To change the lubricant, use the following procedure5Place