2004 Arctic Cat ATVs factory service and repair manual, Page 39Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 39

4To replace the brake pads, use the following procedureARemove the wheelBRemove the cap screws securing the caliper to the
Removal of the right, rear wheel enhances access to the brake components 1Loosen the right-hand jam nut (wheel-side when
viewing from behind) of the adjuster arm EInstall the wheelTightento 5.5 kg-m (40 ft-lb)5Burnish the brake pads (see Burnishing
Brake Pads in this section)2Pull the brake cable to the left and push the adjuster arm to the right Auxiliary Brake CHECKING
3While holding the cable and adjuster arm in this position, finger-tighten the left-hand jam nut until it contacts the adjuster
arm; then loosen it one turn Although the auxiliary brake has been adjusted at the factory, the brake should be checked for
proper operationThe brake must be maintained to be fully functional 4Tighten the right-hand jam nut securely against the