2004 Arctic Cat ATVs factory service and repair manual, Page 61Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 61

Removing Right-Side Components ACover 2Slide the clutch release arm and gear shift shaft out of the crankcase; then in crisscross
pins 3Remove the release roller assemblyAccount for four springs 4Remove the starter clutch-shoe nut (left-hand threads)
and washer from the driveshaft; then using clutch shoe remover, remove the clutch shoe Care must be taken when removing the
nut; it has "left-hand" threadsI NOTE: It will be necessary to remove the lower rear oil filter cover stud and the upper
arm cap screws to provide clearance for removing the cover BRelease Roller Assembly CStarter Clutch Shoe DStarter Clutch