2004 Arctic Cat ATVs factory service and repair manual, Page 79Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 79

Inspect the springs and ratchet for wear or damageInspect the reel and case for cracks or damageInspect the shaft for wear,
seat evenly in the recoil case 6Install the ratchet onto its pln making sure the end is properly installed on the reel 7Install
the shaft7spring7and the spring cover 2Insert the rope through the hole in the reel and tie knot ln the end; then wrap the
rope counterclockwise around the reel leaving approximately 50 cm (20 in of rope free of the reel 3Apply low-temperature
grease to the spring and hub 4Thread the end of the rope through the guide hole of the case; then thread the rope through