2004 Arctic Cat ATVs factory service and repair manual, Page 80Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 80

MEASURING SHIFT FORK (Thickness) W NOTE: Whenever shift fork is out of tolerance, replacement is necessary 1Using calipers,
the reel four turns counterclockwise; then release the rope from the notch and allow the rope to retractPull the rope out
two or three times to check for correct tensionWNOTE: Increasing the rotations in step 11 will increase spring tension 13Place
the gasket and recoil starter assembly into position on the left-side cover noting the location of the single washer; then
tighten the cap screws to 0.8 kg-m (6 ft-lb) 2Shift fork groove width must be within specificationsMEASURING SHIFT FORK TO