2004 Arctic Cat ATVs factory service and repair manual, Page 86Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 86

1If tooth contact pattern is comparable to an incorrect pattern, correct tooth contact according to the following chartTooth
Diameter) 1Insert snap gauge into the upper connecting rod 3.Acceptable gap specifications small end bore; then remove the
gauge and measure it with micrometer Measuring Connecting Rod (Big End Width) 1Using calipers, measure the width of the connecting
rod at the big-end bearingrange must 2Acceptable width specifications Measuring Crankshaft (Runout) 1Place the crankshaft
on set of blocks 2Mount dial indicator and base on the surface platePosition the indicator contact at point of the crankshaft2Maximum
diameter specifications Measuring Connecting Rod (Small End Deflection) 1Place the crankshaft on set of V-blocks and mount
dial indicator and base on the surface platePosition the indicator contact point against the center of the connecting rod
small end journalI ATV-I 074I 2Zero the indicator and push the small end of the connecting rod away from the dial indicator3Maximum