2004 Arctic Cat ATVs factory service and repair manual, Page 96Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 96

I NOTE: The countershaft is now completely assembled for installation Assembling Crankcase Half I NOTE: For ease of assembly,
into the crankcase 5Press the 2nd drive gear onto the countershaft leaving an 0.25 mm (0.010 in gap between the 2nd and 5th
drive gearsINOTE: When pressing the 2nd drive gear onto the countershaft, the inside of the gear must be oil free; then apply
thin, even coat of green Loctite #620 being careful not to get Loctite on the other gears Pressing the 2nd drive gear off
may be done twice before shaft replacement is necessary 4Install the reverse idle shaft; then install washer, bushing, reverse