2004 Arctic Cat ATVs factory service and repair manual, Page 100Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 100

5In crisscrosscase-to-case pattern, tighten the mm cap screws until the halves are correctly joined; then tighten to 2-2.4
center crankcase components, proceed to Installing Right-Side Components, to Installina Left-Side Comonentsand to installing
Top-Side components 3Place the oil strainer into position beneath the crankcase and tighten with the Phillips-head cap screws
(coated with red Loctite #271) securelyThe legs of the strainer must be directed out Installing Right-Side Components AOil
StrainerIOil Pump BGear Shifting Arm I NOTE: If the oil pump was serviced, follow steps 1-2 1Place the oil uumu into uosition
on the crankcase and secure kith the phillips-head screws coated with blue Loctite #243Tighten to kg-m (7 ft-lb) 4Noting
the arrow from disassembly, place the strainer cap into position on the crankcase making sure the O-ring is properly installed