2004 Arctic Cat ATVs factory service and repair manual, Page 102Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 102

The clutch hub and the pressure plate must be seated in the proper positionIf any of the incorrect positions are used, the
1-8 in the preceding sub-section must precede this procedure 9Install the oil pump drive gear onto the crankshaft making
sure the pin is properly positionedI NOTE: The shoulder of the gear must be directed inward 12Using clutch sleeve hub holder,
install the nut and washerTighten to kg-m (58 ft-lb) 10Install the primary driven washer and sleeve onto the countershaft
13Place the primary drive one-way clutch housing onto the crankshaft 14Install the starter clutch shoe and washer; then secure
with the starter clutch-shoe nut (left-hand threads)Tighten to 11 kg-m (79.5 ft-lb) Paae: 102 Arctic Cat ATV 2004 All Models