2004 Arctic Cat ATVs factory service and repair manual, Page 107Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 107

CStator AssemblyCover DStarter Cup ERecoil Starter I NOTE: Steps 1-16 in the preceding sub-section must precede this procedure
the crankcase making sure the alignment pins are in place19Install the cap screws to secure the left-side cover noting the
location of the different-sized cap screws; then only finger-tighten at this time20Place the starter cup into position on
the crankshaft making sure new, lubricated O-ring is inside the cupTighten the nut with lock washer to 3.5 kg-m (25 ft-lb)
Installing Top-Side Components APiston BCylinder 21Tighten the left-side cover caps screws (from step 19) to 0.9-1.3 kg-m