2004 Arctic Cat ATVs factory service and repair manual, Page 110Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 110

I NOTE: Steps 1-4 in the preceding sub-section must precede this procedure 5Place the chain guide into the cylinder 8Install
cylinder head cap nuts and one nut to 2.5 kg-m (18 ft-lb)Tighten the remaining head nuts and the cylinder-to-crankcase nuts
to 1.1 kg-m (8 ft-lb)7Place the head gasket into position on the cylinderPlace the alignment pins into position; then place
the head assembly into position on the cylinder making sure the chain is routed through the chain cavity11Place the C-ring
into position in its groove in the cylinder head 12Install the chain tensioner pad into the cylinder head Page: 110 Arctic