2004 Arctic Cat ATVs factory service and repair manual, Page 126Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 126

W NOTE: Support the connecting rod with rubber bands to avoid damaging the rod or install the Connecting Rod Holder (pln
BRemove each ring by working it toward the dome of the piston while rotating it out of the groove W AT THIS POINT To service
piston, see Servicing Top-Side Components sub-section W AT THIS POINT To service center crankcase components only, proceed
to Removing Left-Side Components 3Remove the flange nut securing the starter cup to the crankshaft; then remove the starter
cupAccount for the O-ring inside the cup Left-Side Components W NOTE: For efficiency, it is preferable to remove and disassemble
only those components which need to be addressed and to service only those componentsThe technician should use discretion
and sound judgment W AT THIS POINT To service any one specific component, only limited disassembly of components may be necessaryNote
the AT THIS POINT information in each sub-sectionW NOTE: The engineltransmission does not have to be removed from the frame