2004 Arctic Cat ATVs factory service and repair manual, Page 141Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 141

2Position the dial indicator contact point on the outside edge of the valve face; then zero the indicator 3If valve guide
the outside edge of the valve faceZero the indicator 2Using the Standard Valve Guide Reamer (pln 0444-017), remove any burrs
or tight areas from the valve guide iournals 3Push the valve from side to side; then from top to bottom 3To install valve
guide, use valve guide installer and gently drive valve guide with retaining clip into the bore from the valve spring side
until the retaining clip just contacts the cylinder head 4Maximum "wobble" deflection must not exceed specificationsMeasuring
Valve Guide (Inside Diameter) 1Insert snap gauge 112 way down into each valve guide bore; then remove the gauge and measure
it with micrometer2Acceptable inside diameter range must be within specifications Page: 141 Arctic Cat ATV 2004 -All Models