2004 Arctic Cat ATVs factory service and repair manual, Page 150Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 150

Clean all componentsInspect the springs and ratchet for wear or damageInspect the reel and case for cracks or damageInspect
unless replacement is necessaryIt should be visually inspected in place to save timeIf replacement is necessary, follow steps
9-10 2Insert the rope through the hole in the reel and tie knot in the end; then wrap the rope counterclockwise around the
reel leaving approximately 50 cm (20 in of rope free ofthe reel3Apply low-temperature grease to the spring and hub 9Remove
the spiral spring from the case by lifting the spring end up and outHold the remainder of the spring with thumbs and alternately
release each thumb to allow the spring to gradually release from the case 10Unwind the rope from the reel and remove the
ropeCleaning and Inspecting I NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
4Thread the end of the rope through the guide hole of the case; then thread the rope through the handle and secure it with