2004 Arctic Cat ATVs factory service and repair manual, Page 158Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 158

3.Acceptable gap specifications range Measuring Connecting Rod (Big End Width) 1Using calipers, measure the width of the
gear, and bushing from the driveshaft ATV-1074 3Zero the indicator and rotate the crankshaft slowly Care should be taken
to support the connecting rod when rotating the crankshaft 4Maximum runout must not exceed specifications I NOTE: Proceed
to check runout on the other end of the crankshaft by positioning the indicator contact at point and following steps 2-4
Measuring Crankshaft (Web-to-Web) 1Using calipers, measure the distance from the outside edge of one web to the outside edge