2004 Arctic Cat ATVs factory service and repair manual, Page 170Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 170

10Install the two gear shift fork shafts; then verify that the two crankcase half alignment pins are in placeI NOTE: Prior
install the seven case half mm cap screws; then tighten only until snugINOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs 2Using plastic mallet, lightly tap the case halves together until cap screws can be installed3From
the right side, install the four case half mm cap screws; then tighten only until snugI NOTE: Rotate the shafts back and
forth to ensure no binding or sticking occursLLUybu 6From the right side, install the five case half mm cap screws (one inside
the case); then tighten only until snugINOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs Page: