2004 Arctic Cat ATVs factory service and repair manual, Page 173Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 173

The clutch sleeve hub and the clutch pressure plate must be seated in the proper positionIf any of the incorrect positions
10Install the primary driven washers and shims onto the driveshaft and crankshaft I NOTE: After placing the primary clutch
assembly onto the shaft, pull out on the pressure plate tower to ensure the pressure plate has engaged the clutch hub properly
and make sure the plates (drive and driven) are brought together tightly prior to tightening the nut securing the clutch
assembly 12Using clutch sleeve hub holder, install the nut and washerTighten to 10 kg-m (72 ft-lb)INOTE: The washer is directionalCare