2004 Arctic Cat ATVs factory service and repair manual, Page 177Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 177

10Install the drive idler gear with one spacer and one washer 13Install the two alignment pins into the left crankcase half11Install
then install the magneto rotor nut on the crankshaft and tighten until the rotor is properly seatedTighten to 16 kg-m (116
ft-lb) DSpeedometer Drive EHiILow Shifter Assembly FRecoil Starter ISteps 1-13 in the preceding sub-section must precede
this procedure 14Place the gasket and left-side cover into position on the crankcaseIIt may be necessary to push or pull