2004 Arctic Cat ATVs factory service and repair manual, Page 179Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 179

Installing Top-Side Components APiston BCylinder 123456789 Cylinder Stud Bolt Stud Bolt Bolt Bolt Bolt Nut Cylinder Gasket
oil rings according to the illustrationI NOTE: Note the direction of the exhaust side of the piston (5) for correct ring
end gap orientation #3 Compression Ring End Gap 2Place the two alignment pins into positionPlace the cylinder gasket into
position; then place piston holder (or suitable substitute) beneath the piston skirt and square the piston in respect to
the crankcaseCompression Ring End Gap OII Ring Expander Endp BInstall the compression rings (1 and 2) so the letter on the
top surface of each ring faces the dome of the pistonRotate the rings until the ring end gaps are on directly opposite sides