2004 Arctic Cat ATVs factory service and repair manual, Page 181Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 181

6Place the head gasket into position on the cylinderPlace the alignment pins into position; then place the head assembly
the nuts (from step 8) to 2.5 kg-m (18 ft-lb)Tighten the cylinder-to-crankcase nuts to 1.1 kg-m (8 ft-lb)10With the timing
inspection plug removed and the chain held tight, rotate the crankshaft until the piston is at top-dead-center11With the
alignment pin installed in the camshaft, loosely place the cam sprocket (with the recessed side facing the camshaft lobes)
onto the camshaft and place it into position with the cam chain over the sprocket 7Install the four cylinder head cap screws