2004 Arctic Cat ATVs factory service and repair manual, Page 184Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 184

Rotate the crankshaft until the first cap screw securing the sprocket to the camshaft can be installed; then install the
then loosen the adjuster screws on the rocker arms in the valve coverApply thin coat of Three Bond Sealant (pln 0636-070)
to the mating surface of the valve coverPlace the valve cover into position making sure the two alignment pins are properly
positionedINOTE: At this point, the rocker arms and adjuster screws must not have pressure on them CWhile holding the valve
adjuster dial in place, use the valve adjuster handle and loosen the jam nut; then rotate the tappet adjuster screw clockwise
until friction is feltDAlien the valve adiuster handle with one of the marks on the valve adjuster dial 28Install the four
top-side cap screws with rubber washers; then install the remaining cap screwsTighten only until snug EWhile holding the
valve adjuster handle in place, rotate the valve adjuster dial counterclockwise until specified valveltappet clearance is