2004 Arctic Cat ATVs factory service and repair manual, Page 187Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 187

11Route the two vent hoses through the slots in the frame12Place the rear outnut shaft into nosition on the rear output joint;
and the mm cap screws to 2.8 kg-m (20 ft-lb); then secure the fender extensions to the footrests with existing hardware18Place
the exhaust pipe into position inside the frame and connect to the muffler at the junctureI NOTE: If the muffler was removed,
see Section 8 14On the 4x4, install the propeller shaft onto the front differential couplerTighten the hardware securely15Place
the reverse shift linkage whushing and washer onto the engine reverse shift shaft and secure with the E-clip 19Place the