2004 Arctic Cat ATVs factory service and repair manual, Page 188Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 188

21Install the gas tank (see Section 4)22Place the right-side and left-side panels into position; then install the existing
of recommended oil into the engineltransmission filler hole; install the filler plug Removing Engine Transmission Many service
procedures can be performed without removing the engineltransmission from the frameClosely observe the note introducing each
sub-section for this important informationW AT THIS POINT If the technician's objective is to servicelreplace left-side cover
oil seals (3), front output joint oil seal (I), rear output joint oil seal (I), andlor the oil strainer (from beneath the
engine1 transmission), the engineltransmission does not have to be removed from the frameIf the engine had major overhaul
or if any major part was replaced, proper engine break-in procedures must be followed (see Section 1)If the proper engine
break-in procedures are not followed, severe engine damage may result Secure the ATV on support stand to elevate the wheels