2004 Arctic Cat ATVs factory service and repair manual, Page 222Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 222

INSPECTING OIL PUMP Servicing Right-Side components W NOTE: Whenever part is worn excessively, cracked, damaged in any way,
STARTER CLUTCH HOUSING 1Inspect the starter clutch housing for burns, marks, scuffs, cracks, scratches, or uneven wear 1Secure
Driven Pulley Compressor (pln 0444-140) in suitable holding fixture such as bench vise; then remove the wing nut, holding
handle7 flat washer, and pilot bushing leaving the large spacer on the compressor tool base 2If the housing is damaged in
any way, the housing must be replacedINSPECTING PRIMARY ONE-WAY DRIVE 1Insert the drive into the clutch housing2Rotate the
inner race by hand and veri the inner race rotates only one direction3If the inner race is locked in place or rotates both
directions3the drive assembly must be replacedLL: 2Place the driven pulley assembly onto the compressor tool base engaging