2004 Arctic Cat ATVs factory service and repair manual, Page 225Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 225

INOTE: Make sure the spacer is on the base or damage to the fixed face will occur when the spring is compressed 2Apply multi-purpose
end with the appropriate anchor hole3Install the three pins and spacers into the fixed face hub; then pack the cam slots
in the movable face with multi-purpose grease 7Assemble the notched-ring nut, spring holding handle, one flat washer, and
the wing nut in order on the pulley compressor bolt; then thread the wing nut onto the bolt 4Install the movable face sleeve