2004 Arctic Cat ATVs factory service and repair manual, Page 229Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 229

COUNTERSHAFT -when disassembling the countershaft, care must be taken to note the direction each major component (dog, gear)
Remove the high driven gear circlip; then remove the high driven gearAccount for the washer, bushing, and bearingAssembling
KEY 1Reverse Driven Gear Dog 2Reverse Driven Gear 3Circlip 4Bearing 5Countershaft 6Low Driven Gear 7Bushing 8High Driven
Gear 9Sliding Dog 10Lock Washer 11Lock Washer 1Place the high driven gear onto the countershaft making sure the bearing,
bushing, and washer are properly positionedSecure with the circlip2Place the sliding dog onto the countershaft; then secure
with the circlipPlace the washer next to the circlipPage: 229 Arctic Cat ATV 2004 -All Models 3Place the low driven gear
onto the countershaft making sure the bearing and bushing are properly positioned; then place the washer onto the shaft 4Place