2004 Arctic Cat ATVs factory service and repair manual, Page 230Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 230

5Place the reverse driven gear dog onto the countershaft; then secure with the circlipI NOTE: The countershaft is now completely
the position of the alignment marks for assembling purposes; then remove driven gear #I with driven gear #2Account for pins
and springsRemove driven gear #2 from gear #I; then account for large washer and keyInspecting 1Inspect the gear, pins, and
keyway for wear2Inspect the springs for damage or fatigueAssembling 1Place driven gear #2 into driven gear #I; then align
the alignment marks of driven gear #I and driven gear #22Using pair of needle-nose pliers, insert each spring part way into
the slot; then install pin and push the springpin assembly into the slot3Place the key and the large washer into position
on the balancer shaft 4Place the driven gear #I assembly onto the balancer shaft; then place the large and small washers