2004 Arctic Cat ATVs factory service and repair manual, Page 233Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 233

Using plastic mallet, lightly tap the case halves together until cap screws can be installedFrom the right side, install
screws to 0.9-1.3 kg-m (6.5-9.5 ft-lb)INOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs CT
AT THIS POINT After completing center crankcase components, proceed to Installing Right-Side Components, to Installing Left-Side
Components, and to Installing Top-Side Components Installing Right-Side Components 4From the left side, install the remaining
crankcase cap screws; then tighten only until snugINOTE: Rotate the shafts back and forth to ensure no binding or sticking
occurs while tightening the cap screws AOil StrainerIOil Pump 1Place the oil strainer and new O-ring into position beneath