2004 Arctic Cat ATVs factory service and repair manual, Page 234Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 234

4Place the pin into position on the oil pump shaft, install the oil pump driven gear making sure the recessed side of the
O-ring is properly installed and secure with the four cap screws; then tighten the oil drain plug to 2.2 kg-m (16 ft-lb)
3Place two alignment pins and the oil pump into position on the crankcase and secure with the Phillips-head screws coated
with blue Loctite #243Tighten to kg-m (7 ft-lb) 5 Install the cam chainI NOTE: Keep tension on the cam chain to avoid damaging