2004 Arctic Cat ATVs factory service and repair manual, Page 237Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 237

20Install two alignment pins and place the V-belt cover gasket into position on the clutch coverInstall the V-belt cover
the threads of the nut with red Loctite #271 and secure the movable drive faceTighten the nut to 10.4-11.8kg-m (75-85 ft-lb)
Installing Left-Side Components AStarter Idler Gears BRotorFlywheel 1Place the crankshaft bearing retainer into positionApply
red Loctite #271 to the three Phillips-head screwsInstall and tighten the three Phillips-head screws securely from between
the driven pulley faces I NOTE: At this point, the wedge can be removed 2Install the starter motor and tighten the two cap