2004 Arctic Cat ATVs factory service and repair manual, Page 239Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 239

9Install two alignment pins and place the left-side cover gasket into positionInstall the left-side coverNoting the different-lengthed
them in this sequence AInstall thin oil ring (3), ring expander (4), and thin oil ring (3) in the bottom groove of the pistonStagger
the end gaps of the upper and lower thin oil rings according to the illustrationFront #I Compression Ring End Gap #3 Thin
#3 Thin Oil Ring Oil Ring End Gap End Gap 10Install the starter cup making sure that the O-ring is in place inside the starter
cupTighten the nut wllock washer to 3.5 kg-m (25 ft-lb) #2 Compression Ring End Gap and Oil Ring Expander End Gap I NOTE:
Note the direction of the exhaust side of the piston (5) for correct ring end gap orientation BInstall the compression rings